D123
Housing material | Bearing at output | Radial load (5mm from flange) | Shaft axial load | Shaft press fit force,max. | Radial play of shaft | Thrust play of shaft | Backlash at no-load |
Metal | Sleeve bearings | ≤0.5Kgf | ≤0.5Kgf | ≤1.5Kgf | ≤0.05mm | ≤0.2mm | ≤3° |
Housing material | Bearing at output | Radial load (5mm from flange) | Shaft axial load | Shaft press fit force,max. | Radial play of shaft | Thrust play of shaft | Backlash at no-load |
Metal | Sleeve bearings | ≤0.5Kgf | ≤0.5Kgf | ≤1.5Kgf | ≤0.05mm | ≤0.2mm | ≤3° |
Module | No. of teeth | Pressure angle | Hole diameter | Reduction ratio. |
0.2 | 12 | 20° | 1.49 | Practicable |
Module | No. of teeth | Pressure angle | Hole diameter | Reduction ratio. |
0.2 | 12 | 20° | 1.49 | Practicable |
Reduction ratio | (Kg.cm Max.) Rated tolerance torque | Max momentary tolerance torque (Kg.cm ) | Efficiency | Length(L-mm) | Weight(g)/Sleeve bearings |
1/4 | 0.8 | 2.4 | 85% | 12.8 | 12.1 |
1/16 | 1.2 | 3.6 | 75% | 16.1 | 14.2 |
1/64 | 2.6 | 4.8 | 65% | 19.4 | 16.3 |
1/256 | 1.8 | 5.4 | 55% | 22.7 | 18.4 |
1/1024 | 2.0 | 6.0 | 45% | 26.0 | 20.5 |
1/4096 | 2.0 | 6.0 | 40% | 29.3 | 22.6 |
Reduction ratio | (Kg.cm Max.) Rated tolerance torque | Max momentary tolerance torque (Kg.cm ) | Efficiency | Length(L-mm) | Weight(g)/Sleeve bearings |
1/4 | 0.8 | 2.4 | 85% | 12.8 | 12.1 |
1/16 | 1.2 | 3.6 | 75% | 16.1 | 14.2 |
1/64 | 2.6 | 4.8 | 65% | 19.4 | 16.3 |
1/256 | 1.8 | 5.4 | 55% | 22.7 | 18.4 |
1/1024 | 2.0 | 6.0 | 45% | 26.0 | 20.5 |
1/4096 | 2.0 | 6.0 | 40% | 29.3 | 22.6 |